Manual De Usuario Siemens Horno 9700 [78/133 Páginas]

Siemens horno 9700

100

101

102

103

104

105

106

107

108

109

110

111

112

113

114

115

116

117

118

119

120

121

122

123

124

125

126

127

128

129

130

131

132

133

Importing Data using DNP 3.0

Data can be imported into the 9700 Power Meter from a DNP control relay or

analog output device. DNP Slave Import modules are used to take a DNP

Analog output or Binary output object and map them into registers.

Using the EtherGate Protocol

The EtherGate protocol can be used on one or more of the XPRESS CARD’s

RS-485 ports, in place of SEAbus, Modbus RTU or DNP 3.0 protocols. The

EtherGate protocol allows the 9700 Power Meter to act as a gateway,

transferring data directly between Ethernet and RS-485 networks.

There are three ways EtherGate can be used to transfer data between

networks. Using the IP Address of the 9700 Power Meter, one of three IP

Service Port numbers (sockets) can be used to direct the flow of data as

follows:

♦

If the IP Service Port is set to 7800, Ethernet data is transferred to both

PRESS CARD RS-485 ports.

♦

If the IP Service Port is set to 7802, Ethernet data is transferred to the

PRESS CARD’S COM 2 RS-485 port only.

♦

If the IP Service Port is set to 7803, Ethernet data is transferred to the

PRESS CARD’S COM 3 RS-485 port only.

Communicating

8LVSYKL

the 9700 Power Meter

In the basic EtherGate configuration, your WinPM workstation connects to

the X

PRESS CARD’s Ethernet port, and an RS-485 loop of devices connects to

the X

PRESS CARD’s COM2 or COM3 RS-485 port (or both, if you have two RS-

485 loops). In this configuration you communicate with the RS-485 loop

through

the 9700 Power Meter (the 9700 Power Meter acts as the gateway).

Using the Internal Modem

This section describes the operation of the 9700 Power Meter internal

modem. This section only applies if you have ordered the –MDM (or –

MDMC) option.

Before installing or using your 9700 Power Meter, make sure that you are

familiar with the FCC and Industry Canada warnings located at start of this

manual, as well as the

Installation and Basic Setup Instructions

included

with the device.

manualesoceanicos.es

Información

Siemens horno HB30D50U

Siemens horno HB 300.50

Siemens horno HB30D51UC

Siemens horno HB 300.80

Siemens horno HB875G8B1

Siemens horno VB578D0S0

Siemens horno HB55NB550B

Siemens horno HB77L55

Siemens horno HB331

Siemens horno hb79e54

Siemens horno HF 770

Siemens horno BF525LMW0

Siemens horno BF425LMB0

Siemens horno HB44045

Siemens horno HB835GPS1

manualesoceanicos.es

Información